27371

Technical Characteristics

• Actuator Travel Control Feature

  stops

• Terminal Type And Quantity

  6 turret

• Power Dissipation Rating Per Section In Watts

  2.0 free air all sections

• Electrical Resistance Per Section

  1.0 gallons per minute c and better industrial clears

• Section Quantity

  2

• Body Style

  cylindrical bushing mounted

• Function Characteristic Per Section

  all sections linear

• Nonturn Device Location

  at 12 oclock

• Overall Length

  2.381 inches maximum

• Shaft Bearing Type

  sleeve

• Screw Thread Diameter

  0.375 inches nominal

• Body Length

  1.490 inches maximum

• Shaft Style

  round

• Ambient Temp In Deg Celsius Per Section At Full Rated Power

  80.0 all sections

• Screw Thread Quantity Per Inch

  32.0

• Overall Diameter

  1.524 inches maximum

• Shaft Length

  0.875 inches nominal

• Terminal Location

  radially positioned over less than half the circumference

• Nonturn Device Radius

  0.500 inches nominal

• Mounting Method

  standard bushing

• Mounting Bushing Length

  0.250 inches nominal

• Rotary Actuator Travel In Angular Deg

  354.0 nominal

• Function Conformity Tolerance Per Section

  -0.50/+0.50 single section

• Screw Thread Series Designator

  unef

• Resistance Tolerance Per Section In Percent

  -10.0/+10.0 2nd section

• Effective Electrical Rotation In Deg Angular Rotation

  354.0 nominal

• Reliability Indicator

  not established

• Actuator Type

  single shaft

• Body Diameter

  1.312 inches nominal

• Function Conformity Per Section

  all sections independent linearity

• Electrical Resistance Per Section

  5.0 percent, rated amperes c and better finish

• Ambient Temp In Deg Celsius Per Section At Zero Percent Rated Power

  125.0 all sections

• Resistance Tolerance Per Section In Percent

  -5.0/+5.0 1st section

• Test Data Document

  10001-2324209 drawing (this is the basic governing drawing, such as a contractor drawing, original equipment manufacturer drawing, etc.; excludes any specification, standard or other document that may be referenced in a basic governing drawing)

• Shaft Diameter

  0.1245 inches minimum and 0.1248 inches maximum